Garage door won't close: sensor repair in Milford

If the door won't close from the remote and the opener light blinks, the sensors are the first place to look.

Call (475) 271-1379

In short

A garage door that won't close from the remote is most often a sensor problem, not a broken door. In Milford, a technician checks the photo-eyes and wiring, resets the travel and force, and confirms the door reverses on contact before leaving. Don't bypass the sensors in the meantime.

Chain-drive garage door opener under exposed rafters

Doors that won't close in Milford

Milford has 17 miles of coastline, and salt air is hard on the small things. In Woodmont, Walnut Beach and around the harbor, sensor brackets rust, the lenses fog with salt film, and the low-voltage wire corrodes at its connections. Wiping the lenses helps for a while. When the lights keep dropping out, the wiring usually needs to be redone with the connections sealed. Inland, along Wheelers Farm Road, the more common cause is simply a bracket knocked out of line.

What it means when the door won't go down

Every opener made since 1993 has two photo-eyes a few inches above the floor, one on each side of the door. If the beam between them is broken, or the opener cannot tell whether it is, the door will not close from the remote.

  • Blinking sensor light: the eyes are out of line or one lens is dirty.
  • Both lights off: no power to the sensors, usually a wire pulled loose or chewed.
  • Lights steady but the door still reverses: the problem is the close limit, the force setting, or something binding in the track.

What you can safely try yourself

Clear the doorway, clean both sensor lenses, and check that the two sensors point at each other at the same height. A steady light on each side means they can see each other. If one keeps blinking after that, or the wires look damaged, leave it for the technician.

Never disconnect the sensors or move them up out of the doorway to get the door working. They are what stops the door from closing on a child, a pet or a car.

What the technician does

  1. Checks power and wiring to both sensors and repairs any break.
  2. Realigns the sensors, or replaces the pair if one has failed.
  3. Resets the open and close travel so the door seals without straining.
  4. Tests the automatic reverse on an object in the doorway and with the beam blocked.

Around Milford

  • Downtown and the harbor: Older homes around the green and the Wepawaug River.
  • Post Road North: Ranches and capes above Route 1.

See the full Milford service area.

Door stuck? Call before you try to force it.

Springs and cables hold a lot of tension. Don't lift the door by hand or keep pressing the opener; call and we'll book a technician.

Call (475) 271-1379
Call (475) 271-1379